Plastic pipe production lines must be inspected and maintained regularly

We know that in the production of plastic pipes, the most important part is the cooling part. If the product extruded from the mold cannot be cooled quickly under high temperature, then the parameters it brings will not be controlled. Generally speaking, after entering the cooling water tank, the surface temperature of the pipe should be between 20 and 25 degrees Celsius. In the past, the use of artificial production methods completely relied on the experience of professional and technical workers, which greatly restricted production efficiency, so the use of plastic pipe production lines is inevitable.

Manual production will result in a lot of defective products, and the yield rate is not high. With the use of plastic pipe production lines, such problems have been solved. However, the use of this new production line has increased the requirements for safety maintenance. If the water temperature of the machine cannot be controlled, the worker should quickly check the waterway to see if there is any blockage. If the water surface temperature obviously exceeds the calibrated temperature during operation, the sizing sleeve should be checked immediately and measured. If it is found to be damaged, contact the supplier immediately and ask them to send new accessories to avoid losses caused by batches of defective products.

The maintenance of plastic pipe production lines must be carried out regularly. Not only should major inspections be carried out every month, but also technical workers should conduct inspections before starting production every day. If there are many burrs on the surface of the products during the production process, it is likely that in the previous production process, some residues of production materials were not cleaned up in time, and some uneven quality conditions may occur during production. The general experience is that if the traction machine fails, the parameters of the products produced will often be unqualified.